So I have been trying to replace the OE brake assembly on the back of my '96 gsx. I have everything together now and have yet to flush/bleed everything when I notice the original brake line (the rubber soft ones) are not mating flush with the new calipers... I ordered the powerstop rear brake...

I picked up my 1998 Eclipse 2.0l (420a), 5 speed manual (NV-T350) a few years ago. It came home with me on a trailer and in numerous boxes of parts. I also found a 1997 a couple of months later that had been rear-ended and picked it up for nearly nothing to use as a parts car. Several trips to...

Need to sell this stuff. Let me know what you need and make your best offer. Prices are negotiable just need this stuff gone 312 536 8787 MarioBaer big brake kit (front) 2g- 450 plus shippingAEM EMS V1- 450 shippedtaylor battery box- 75 shippedhalf radiator- 100mishimoto hoses red - 40...

Greetings tuners, I got a good condition "95 Eclipse GSX CA emission eprom ecu up for grabs part number on the case is MD312464 , it has no signs of damage or any funny smells, it has to be sent to dsmlink to have them socket it if you plan to run dsmlink with it I'm asking $155 shipped 3 day...

Im selling my 95 talon tsi awd $ 7500 very low miles 60,000 in great condition one owner car its stock and has been garage kept.it sold

This thing has so many more wires than the Innovate mtx-l+ that I have. I'm not sure what wires to use. The innovate really only uses 3. If I'm wiring this thing up similarly I'm going to need power, ground, and signal. The signal wires are analog wires are white (analog +) and brown (analog -)...

97 GST w/ 95k on motor New paint, wheels, tires. Custom fender pull. Too much to list. Well cared for car. Interior is the cleanest you will ever see in a 2G. Plastics are scratch free.I bought this car bone stock 3 or so years ago. Car came from a Doctor that just used it to drive to work...

Having a strange problem with my 98 GSX where the car is not getting any power at all until I disconnect and reconnect the battery. The issue doesn’t happen every time but both times the issue happened, I drove the car for a short time, turned the car off and then once I go to start it again the...

I've been trying to diagnose a new problem - car stumbles/hesitates horribly under high boost. Zeitronix ZT2 wideband O2 reads a lamba of 1.00 at all times, AFR stays at 14.8 during accelaration or lift, only sometimes flickering to 14.7.So the question... is this a likely symptom of sensor...

Jacob5se submitted a new DSM Profile :You must be registered to see element.You must be registered to see element.

Hello, i Have a 1999 Mitsubishi Eclipse GST that's been having troubles picking up FM radio stations. The radio in question is the stock CD/cassette player AM/FM Infinity radio.I had just figured out my radios code and replaced my old broken antenna, only to find that my radio was only picking...

Does anyone know what is required to convert these ugly drums to discs on the rear? Is it possible to maintain emergency brake functionality? Where would be the cheapest place to buy a kit? And amount of time required to install? I was looking for a little more braking performance.

Anyone know if the rear lower shock mount on a 2g gsx is available to buy somewhere? Its the mount the goes into the knuckle then the shock slides onto it then the 17mm bolt threads inside of it.

Hey Guys/Girls Ive owned a 95 GST for about 4 years and used it as a daily until today. I pulled a used 7 bolt from a bone yard last week and undressed it. i will be sending out the block to get a magnaflux done to confirm i have a strong block. I'm excited for the build! knowing its only FWD i...

Hey guys I live in Kansas where it's been 20 degrees and below lately. Since it's been this cold my car has started smoking like my turbo has blown. And I'm driving on aa rebuilt 16g I'm not sure if I just need to wait longer before driving it or what. Any thoughts on what it could be? It...

I will try and make this long story short, I loaned my car out to my brother inlaw to drive to school for a bit and one day he said there was something wrong with it. That trip ended with him stranded on the side of the road and the clutch toasted on the car. I went to get the car with a...

Hey guys,I went through the car wash and as I was leaving and pulling up to the stop sign, the car died and has not started back up.I checked under the hood and the battery was covered in water so I dried it off in a quick attempt to fix the problem. Nothing. I have not begun the diagnosis...

Hello guys.. sorry if i'm posting in the wrong place i'm new here... so anyway since we are now in winter my Antenna refuses to come fully up which i expected i always thought about disconnecting it, my first guess was to disconnect it on the Head Unit well dumb me it Antenna still worked ouf...

so I’m looking into buying a 1998 Eclipse GSX, and I’ve test drove it and everything and it runs smooth and shifts fine and everything is good except, it has rust. And I know rust is car cancer and you should for the most part steer clear of a car with it, but it’s a rare car for only 2500$ and...

2g oem radiator came off a 95 n/a m/t was replaced by past owner before car was parked for 1 month. It does not fit in my 1g comes with both fans 140 oboHolset h1c turbo has 0 shaft play in/out. Came off motor with 20k miles when i bought it. Needs compressor housing clamp. 240 obo1g dash...

You must be registered to see element. You must be registered to see element. I have a new unopened center force dual friction clutch kit. Bought it for my 97 Eagle Talon TSI FWD 4G63T but never finished the car. Im trying to get rid of the parts I have stashed in the garage. $350 OBO through...

Hello I am selling my Tsi racecar project along with every part I have collected for it. the car runs and drives and has a clean title. asking 3700 for the whole lot.Mods: AEM Dry Flow Filter (does not use oil)Evo 3 16g turbo (Only 1000 miles on it)Evo 8 Blow off valveAeromotive...

There is a guy in my area selling an evo 3 eprom ecu. I'm prepping to get ecmlink and my buddy told me I could save a bit of money with the eprom because I wouldn't have to get the full ecmlink package. Does the evo 3 eprom ecu work in a 2g dsm? If so, what else do I have to buy to get ecmlink...

james green submitted a new DSM Profile :You must be registered to see element.You must be registered to see element.

Hi everyone, first post here and I have a question about adjusting the accelerator cable on my 98 eclipse GSX. There is about a quarter to half an inch of the accelerator cable that sticks out from my gas pedal. This causes the pedal to move a bit before you can give it any gas (the pedal moves...

Hey guys I was looking for some help on my 2gb dsm. I recently just installed new 9006 bulbs for my low beam headlamps and they only work when i have my highbeams on as well as when i flash the headlights. All my fuses are good and the headlamp bulb wiring seems fine, however i do have two wires...

First test drive of my 96 GSX was great but theres a couple things i cant find answers for, first of all i loosened my bov so i could adjust it and make sure its functioning properly like always but for the first time the adjuster got blown out, granted it was soft af but snugged in place, yes...

I just got my DSM Saturday and I went to pass someone on the way to work and a mist blew out the side of the engine bay. Now it won't stay running and idles rough. I had to pull of the side of the road because I lost most of my power. When I use the accrlerator it revs up a little for a second...

Hey guys, I recently upgraded my fuel system to accommodate more power. I have installed a DW 255 fuel pump(rewired), fic rail and 750cc injectors, and Aeromotive fpr. I have set the fuel pressure to 42.6 or as close as I can get to it. I have tried setting the global fuel to -39.8% and global...

Does anyone know how to steal proof fog light bezels for the 2gb bumper? Before I put on my fogs for the fall i want to make sure they can't get stolen. i live in SoCal and these are discontinued so i don't doubt dsmers will be envious.

Hey guys,I either dont know the proper terminology or I didnt do a thorough search but I cant find an answer for this issue. I bought an AWD Talon that was at the beginning stages of being parted out and one thing that was parted was both fuel sending units. These are very hard to find but I...

Hi I have a EU spec 2g with a stock 2g 7bolt N/A 4G63 (which basically acts as a 4G64). I have the found a good deal on a 1G valve cover+head+intake+throttle body combo (all stock). I wanted to change the valve cover for a long time now, because it is cracked. The quiestion is, is this setup...

Includes: car cover, laptop, escort passport radar detector, dealership service manuals, and much more!This car was purchased in 2004. It has been garage kept in the winter time. This is the cleanest DSM in Northeast Ohio. Please see details below of this rare gem.-6 bolt engine -5 speed...

I've got a 2g gst and I live in Kansas. Any time the temperature drops below maybe 40 degrees the car has difficulties staying running. I notice the lights on the dash are not as bright as the first symptom. After that it starts misfiring and sputtering. After that it dies altogether and wont...

Is there anyone who may be able to help me out i recently just swapped my harness and alternator after a small fire for my 2g 6 bolt and my lights and radio work but when trying to start the car nothing happens. battery is good and i just put a new starter in not completely sure if its set up...

Hey guys, Ive searched and searched but there were no specific results to my question. I have a 96 Talon TSI, FWD M/T non ABS and I bought a 95 Talon AWD M/T with ABS shell that I plan to build from my 96 talon. I need to know if I can use my entire Engine harness from the FWD Talon for the AWD...

Hey guys, I just picked up an Evo3 16g for a hundred bucks. The turbine wheel looks a bit worse for wear and I would like to replace it. Any suggestions on who to go to for rebuild and balance?

Hey fellas,I was wondering if anybody has swapped on one of the k tuned throttle bodies. They are a really good throttle body and they have an option for one of the mustang flanges that are commonly used. I would like to put one on my car at some point but would like to know if anybody else...

Hey guys I'm having some trouble diagnosing whats causing me to not have spark. Compression is ok ~150 across. Plugs are brand new and gapped. Coils we're testing bad and replaced. Used one of those power probes and found power at the plug for my ignition module but not after so I replaced it...

Most instructions (fsm included) say the first step to working on the sunroof is lifting it with the motor. If you dont have a working motor (check your fuses, relays, and switch), if the car is in a junk yard, or the car has no power for any reason then this is the place to be.1. Remove the...

I just put my '99 GSX back together after replacing the clutch. I put my old battery back in (which worked fine before but has been sitting for months) and attached a jump starter to the contacts. I also made sure it was grounded from the negative contact, the same way as it was before. First...

Some background: During the summer of 2015, after nearly a decade of daily driving, my '96 TSIAWD (stock with the exception of a 14b swap) developed a nasty exhaust leak so I parked it. It ran fine otherwise. Sometime in early 2016, I attempted to start the car, but realized the battery harness...

So since ive gotten my 99 eclipse with the 420a (a/t) i have loved it. But theres been one thing thats bothering me. And now that ive done a bunch of repairs with the general maintenence to fix the previous owners neglect, theres one thing that i really just have to figure out. So my problem is...

I would move my forum to the proper place bur am a probationary member so i apologize for that. Also i understand some of these issues have threads regarding them but they dont have my specific questions answered in thpse threads. So ive done a crap load of research on forced induction...

Alright guys here's the question. How exactly do I replace valve stem seals with the head on the block? I attempted it once before about a month or two ago and apparently I did it wrong because its smoking and one of my spark plugs was soaked in oil, and this was after about 2 weeks of doing...

Hey I just bought my shell not too long ago and got the engine bay painted and bout to put the motor in out of my 97 GST in it just wondering what maintenance i should do on it before I put the Motor in? I was thinking timing belt (obviously), tensioner, idler pulleys, water pump, intake...

You must be registered to see element.Ive been looking for a car for a while now and have been eying this for a couple of days. I would be a first time dsm owner and was wondering if there were any red flags people could spot. Ive tried to do my research and ask the owner the right questions...

Hello, I'm a proud owner of a 2g dsm 4G63 N/A in Portugal but currently, my happiness levels have been decreasing... Here's the scenario: The car is stock (except for the exhaust which has no catalytic converter anymore) and under full throttle, it stutters around 4.5k rpm (it gives the...

hey guys, I'm working on my 2g and when I tried to pressurize the cylinder so I could compress the spring, the crank spun. I don't know which direction it spun and I don't know if that means I now have to do timing. I unbolted the cam gears from the cams and had the belt still on it. I didn't...