Installing internal gate on BEP HX40 housing.

[forcefed86]

Anyone done this before? For packaging reasons I was thinking of doing my new BEP setup this way.

I saw these on Ebay...

Turbo Internal Wastegate Swing Valve Linkage Comp. 33 Straight Arm Holset WHIC | eBay

These have the smaller "Arm"

http://www.ebay.com/itm/Turbo-Swing...Parts_Accessories&hash=item5886950a1f&vxp=mtr

Anyone know if these will work? Or what size "Arm" is needed? Any info appreciated.

 

[JusMX141]

That flapper is so small it would fall right through the hole in the Bullseye housing.

It's highly recommended that you do not use an internal gate with a HX40. It's also highly recommended that should you choose to do so, you buy the hardware from Bullseye or one of their dealers so it fits properly.

 

[forcefed86]

That flapper is so small it would fall right through the hole in the Bullseye housing.

It's highly recommended that you do not use an internal gate with a HX40. It's also highly recommended that should you choose to do so, you buy the hardware from Bullseye or one of their dealers so it fits properly.

I didn't know it was something they actually sold. SUppose I can try to contact them and ask.

Thanks.