Whats up fella's, back again.
Got the trans pulled, New master clutch master cylinder, New turbine housing, Billet shifter mount brackets, New solid hub puck.I picked up a little red LED to get installed as a shift light. 9k comes up so fast...
Got started today on pulling the trans and turbo kit.
Needs a new TOB and I'm swapping in a solid hub 6 puck disk after recommendations on it.
I'm torn on pulling the midcase in the trans to check out 3rd and everything else to see if something...
Spent the day today doing some simple "creature comforts"Since having the car the dome lights haven't worked when the doors are opened. So I went ahead and pulled the door close sensors off and the driver side was completely unplugged and...
Yeah I have a small momentary switch on the center console.
It's worth mentioning that I'm in a standalone ECU too, although you can set up rolling antilag in ECM Link also.
The master is adjusted all the way out, and and same with the clutch stop.I think like Kurt says it's a hydraulic issue with the 2900 pressure plate. It needs more fluid for more travel, hence why the wildwood master and what not.
Resonator wasn't a Huge game changer for me. It made the car about 10% more quite and make the drone not SO bad but it still drones a little bit.Now, muffler.. that was a game changer.
You don't see the big automotive media outlets focus on DSMs too much, so it's cool to see this article on AutoEvolution..."Mike's V8-powered supercar has to prove itself against Ronnie's heavily modified Eagle Talon, which allegedly makes 800...
Well spent a few hours today and installed my JXB Carrier Bearings and pulled my shifter cables to figure out why getting over to reverse / 5th was so hard. I wasn't disappointed.I started with the rear bearing and got the old one cut off and...
I need to do more looking into it but I don't know if the 1g will fit due to my throttle body linkage being on the opposite side of OEM. May need to look at fitting up the 2g brackets but I appreciate it
Pulled shifter cables because it's been hard to get into 5/ reverse since I bought the car.Not to my surprise, found the end of the shifter cables bentWas actually able to bend it straight and now 5/R is butter!
You let me know if you wanna do that! I'll take it haha I don't have one. It's definitely really cool to have something to compare to so many others. Or if you can't make it to the strip often
Borrowed by brothers dragy and took the car out for my first EVER 60-130. Granny shifting for sure. Clean up the shifts and for sure it'll be like a low 6 second at least.I really want to take it to the track and see what it'll do but it...