cylinder head work

[spwelsh]

hey guys, here's what's happeninng right now, I did a port and polish on the head, crane valve springs and stage one crower cams, the car runs and idles fine (on 7" of vacuum). However after I take it out of gear (comming off of a load) the engine stalls out even rolling down a hill on an idle the car will stall out. Any help would be great!!!!!

 

[BigRand]

Sounds like a vaccume leak....

 

[VelocitàPaola]

Or messed up timing... are you sure the timing is correct?

 

[spwelsh]

Thanks, turns out the timming belt was off by 2 teeth

 

[cimotorsports]

Hey Sean make sure to send me some picts of your car when you get a chance.. nice to know you got that head on and got it running!

 

[rcjr9186]

that will do it, when putting the belt back on remember when you get the timing marks lined back up, to turn them the oposite way they normally spin by about 1/2 a tooth. this is so when you get the belt back on and put the tensioner on there... it will pull the gears back to dead even.