The Central Hub for DSM Community and Information

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. This is where the DSM platform history is documented and archived. Log in to help us in our mission, and to remove most ads from the browsing experience.

Post a Question

1G AEM Wideband O2 install

Please Support Morrison Fabrication

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Breadvans

Proven Member
175
15
May 16, 2021
Harrisburg, Oregon
I got an aem wideband gauge, and I’m going to install it in the front o2 housing. I was wondering if it’s possible to just cut the old o2 wires and solder and heat shrink the new wires with the old and have no problems? I know the wideband is 5v and the stock is 1v so I’m not sure
 
No Beuno. The wide band sensor is a 4.2 or 4.9 unit. The original is a "narrowband" and will not work with the AEM gauge, to my knowledge.
 
Add Value - Be Respectful - No Trolling - No Misinformation - Participate Often!

Similar threads

wolf alchemy
1G AEM wideband install
Replies
24
Views
11K
wolf alchemy
wolf alchemy
v8s_are_slow
2G AEM Wideband wiring to rear O2
2
Replies
31
Views
15K
v8s_are_slow
v8s_are_slow
AEM wideband problem
Replies
11
Views
12K
kornfedgsx
Aproductions
Resolved Depinning AEM wideband
Replies
3
Views
6K
m_0ney_pit
m_0ney_pit
GHSTII
2G Getting That Rear O2 Sensor Through The Floor | Wideband Gauge
Replies
12
Views
4K
GHSTII
GHSTII
Boosted Fabrication
ECM Tuning
ExtremePSI
FIBA Motorsport
Fuel Injector Clinic
Innovation Products
Jacks Transmissions
JNZ Tuning
Kiggly Racing
Morrison Fabrications
Rix Racing
STM Tuned
Support Vendors who Support the DSM Community

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds

Back
Top