What did you do to your DSM today?

[clipseGSeX]

changing plugs, wires, oil, all the reg maintenance, cost stomped on by a pretty sick evo earlier so i had to go pick on a few hondas before i could come home an start

 

[ktgurl87]

i attempted to replace the starter... then the car bit me.. so i'm leaving her alone to think about what she's done. i also took the turbo apart and painted the hot side black so it looks nice replaced the o2 housing studs (going to the downpipe) and... made new gaskets for the oil return line so i ripped one if half and the other one is filthy heh.

 

[ncampos92562]

The timing rebuild and ARP install begins.

You must be logged in to view this image or video.

 

[914g63gsx]

went outside looked at it and went back inside . brrr its to cold out to mess with anything

 

[907gs-t]

Pulled mine back in the garage to keep the Snow from dumping on it.

 

[my dreamt dsm]

Looked at it. Pity it. Kicked a rim because of my neglect.
Hate driving with a popping axle and waiting for the new one to come. Hopefully it's the axle and not the hub. Talk about attention. Try driving when everyone around you is looking for a popping noise.

 

[gst96spyderman]

Reconfirmed from about 3 weeks ago that the hg needs replacing, after driving for a few minutes. Damnit... But thats okay. I'm going to get to buy some new parts for her and some new toys also... Also found an 18g turbo for crazy cheap... Be a nice back up if the 16g get boring. Can't wait to look in classified for stuff I don't NEED instead I'm looking for things I would spend some real time researching, but now need to hurry up to get hg repaired... Just to look around and say, hey! I want to get those 660's, or awd conversion isn't THAT expensive...

 

[HaveBlue83]

$214. YESSSSSS. cleaned and about to be installed...

You must be logged in to view this image or video.

and these bits too for $20:

You must be logged in to view this image or video.

 

[ktgurl87]

finally got the new starter on. fully installed the exhaust manifold, turbo and intake pipe. still have a couple lines to plug up. she's coming along one cuss word at a time

 

[ewyss]

try to put a new cts in my car and reatache the wires to it in the pouring rain outside, not fun

 

[Silver99OZ]

I adjusted the latch on my hatch so now it actually opens properly.

 

[VxminhxL]

Finally got dsm link v2 with eprom and apfr kit! =)

 

[914g63gsx]

i drove it with no problems go me haha. and i was like good car good car now get me home...

 

[92AWDHX40]

Lookking for loose wires, working on trim clips, and pieces.

 

[Gs Dewd]

moved from one side of the driveway to the other to make room to get the MCSS out.

 

[wings9191]

Pulled the steering wheel off and pushed it outside.

 

[SOADweskey]

I put the oil pan, intake manifold, exhaust manifold, oil filter housing, and turbo on the engine. Also put a DEI turbo blanket on the hotside. Getting damn close to putting an engine in the GSX again.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

 

[dsmTripp]

Well I got an xs power tube Mani along with an xs power o2 with atmosphere dump. So I pulled the Turbo, exhaust mani, and old o2 housing. Thought about other things and ended up pulling front bumper. Noticed with my passenger front strut tower that some cheap a$$ bonding looking job was cracking and flaking up so I ripped all of it off to find a huge rusted gaping hole. Kinda sad about that one. Oh well more welding practice here I come! Thought about where to mount my old school hks catch can and didn't find a proper place with room. Contemplating relocating the battery for extra room. Wishing for a bigger Turbo along with link v3. Also wishing the Guy wanting to buy my gsx would come and say yes or no So its either gone or I can officially start parting it out/ taking parts for my awd conversion. So yup pretty much all I've done with my cars today thanks to my new heater for my garage. Toasty oh yea!

 

[ratatack]

Had my car towed to my house where its been sitting in one spot for about two months diagnosed the problem now kicking my self for being such a idiot hopefully my car will be running the next weekend i have off.

 

[Gs Dewd]

I lifted the head on my first engine in the 94'. It took a good day to replace the head gasket. so you'll get it.

 

[SmalltownDSMer]

Did a little spring cleaning in the winter. Removed the sideskirts and cleaned everything.

Jayson

 

[Billiam]

Looked at parts for her, and looked at pictures of her. I'm in colorado and she is back in illinois so that's all I can really do...

 

[tazndrew04]

thinking about this spring when i can drive her agian and not just start her bc shes in a garage so that will be a fun day and checked for leaks

 

[gst96spyderman]

Blew a stack on her. cometic mls HG, hallman pro evo mbc, timing belt kit, gasket kit, h20 pump, thermostat, tail 38mm, AC condensor, balance shaft eliminator kit, valve cover kit... Still looking for bumper, side skirts, hood, lights, foglights, arp head studs?, valve cover, and car cover. Wishing I could drive her in the snow... Also REALLY wanting to find a GSX parts car to do awd swap before spring.

 

[dsmrollerz90]

All new exhaust gaskets, new o2 housing, ported turbine housing, alt. swap, rewired coolant sensors