Megasquirt with no RPM signal

[Lilbloody4]

I have MS2 installed on my 4G63 and for some reason I'm not getting a RPM signal... Everything else is showing up but without a RPM signal of 300, the MS2 won't run the startup enrichments... Does anyone have any information about the 1G CAS sensor connection to the MS2 for RPM signal???

 

[blazinglaser_90]

Can you post up a picture of how you have your board setup?

It kinda sounds like your not getting a cam signal into the ecu to sync the rpm signal, a few things that could help me figure this out for you are

1. picture of the top side and bottom side of your megasquirt board
2. a copy of your tune *msq file*
3. a data log of you cranking the engine over so i can check for any sign of rpm signal and lack of a cam reset signal


Kevin