Frank 20g spool up

[jed344]

Mods are listed on profile i am on pump gas at 23psi tuned by myself. I see full boost of 23psi around 4400 rpm is this normal for a frank lvl 3 with clipped exhaust wheel? It just seems terribly slow spooling to me.

 

[JusMX141]

Seems a little lazy to me for that turbo....that's creeping up on FP Red territory.

 

[black97spyder]

Well that makes me feel horrible about my 16g. Ik I have problems but didn't think they were that bad. I see 16psi in 3rd gear at 4200ish rpm..... DEF time for a rebuild on mine!

 

[jed344]

Any idea y it's spooling slow ish? I'm bout to just take it off and run a hx35 in bep housing

 

[black97spyder]

Do you have any pre-turbo exhaust leaks or boost leaks? That would cause it to spool slow. Also if you have a lot of backpressure in your exhaust, that will hinder spool time as well

 

[T is for TURBO]

Check the flex section in the down pipe. There have been instances where they will collapse and cause terrible boost response

 

[jed344]

No leaks anywhere have checked it all i added some pre boost timing and it helped a little now right around 4200rpm it hits 23psi.