Just got my DSMLINK v3 installed yesterday and finally had the time to start cruising and doing some pulls. I noticed it's pretty regular that I get knock ranging from 3-10 any time that I do a WOT pull. I'm very novice at tuning but I did manage to get my idle near perfect my airflowperrev is a...
-$13,000–
For Trade or Sale
95 clean title 148k miles on chassis, 5k miles on built motor, 3k miles on rebuilt turbo, trans and full refresh 500miles ago
7 bolt
Eagle rods
Wiseco pistons 9:1 comp.
BS delete
Gates timing belt
Kiggly HLA
L19 arp headstuds
Mls headgasket
Evo 3 intake Manifold
Fp...
I have a 1997 GSX that the previous owner had put in a black box ECU, I am having trouble finding a shop that will tune it. I was told by english racing if I install an Evo 8 ECU they will tune the car.I found this guide...
Ok so I have all of my timing marks aligned correctly. I am trying to install the belt but it does not have enough slack, I have the tensioner pulley completely lose and the grenade pin still inserted in the auto tensioner. I followed the vfaq for correct routing and that does not work. All my...
Trying to get my intake manifold off but I have no idea how I am suppose to access the lower bolts... I have tried with everything that I have to get a socket or wrench on there. The design is dumb it has the bolts positioned right under the runners I can barely squeeze my arm under there with a...
I have a 1995 eclipse Gsx and as I was doing the battery relocation I unplugged the two White Main power wires from the fuse box (in the picture below) One of them has a small wire (white with red) connected to the one of the main power wires but I can’t remember which spot the main power wire...
(Parts for sale located in Sylmar 91342 /Palmdale 93591 CA)90 GSX parts2 core alum radiator
$100 (OBO)
Upper and Lower radiator hose
(SOLD)
Balance shaft -Belt (New never opened)
$40 (OBO)
Balance shaft tensioner (New never opened)
$45 (OBO)*Edit* got my car tuned on 7/23/2020 and...
So my 95 eclipse GSX has had engine cutout on and off recently while on the road, and now it wont start at all. No spark, no fuel. My research suggests to check the Cam angle sensor (Cam), then the Crank Position sensor, then finally send the AEM engine management system (ems) back to be...
So my '96 gsx is leaking and I cant seem to see the exact origin? It seems to be dripping off the passenger side axle so I assume its that seal on the tcase. I read that its pretty easy to drop the t case and replace these seals (easier than the whole front side of the engine's seals anyway)...
Anyone know the best place to get some quality but also reasonable priced rattle cans? I need some Cayenne red pearl for my 2g eclipse. I plan to paint my side skirts and door handle to match the rest of the car.
So finally got my cruising AFR up to around 13 and out of no where a day later they just went to 11 and it wants to stay there. My Idle and WOT did not change at all so it has me confused. Any ideas on what could change cruising AFR but not change the WOT and idle?
Out of these two which do you guys prefer?https://www.rockauto.com/en/moreinfo.php?pk=279645&cc=1205873&jsn=9&jsn=9
https://www.rockauto.com/en/moreinfo.php?pk=991899&cc=1205873Also a side question.. If you had the option for 850cc, 660cc, or 560cc injectors for my Small 16g, 2.3l with a...
So still tinkering with my tune to get AFR set perfect. I have seem to get idle to be near perfect it still shows a little rich after pulling up to a stop light around 12.5 then eventually comes back to around 14.However when I let the car idle for 16+ minutes my fuel trims never changed, I...
hey everyone I'm looking for a running good condition tsi or gsx rather it be closer to stock but just let me know what you have if your in my area that be great feel free to call/text 9732197420 vinny
Just got a sensor installed and my wideband gauge hooked up. At idle the car sits around 13.5 then cruising it's really rich at around 10.3-10.5. When I come up to a light and idle it's around 11.7 idle however once the car sits idle for a while it will go to 13.5. WOT it pegs at 10.0 and I...
Hey guys.. I just recently fixed some electrical issues with my gsx, only to be welcomed with the amazing sound of something knocking / ticking in the engine!Just when I thought everything was perfect... lol. Just kidding, I'm glad to be apart of the DSM World!I'm really hoping this sound is...
So I recently rebuilt my throttle body and it will still leaking after putting it back on the car. Well today I removed the throttle body and used a dremel with a soft wire brush to clean and even out both sides of the throttle body, intake manifold, and throttle body elbow. I also placed...
Selling a white 2nd gen gsx spoiler in good condition: Make an offerAlso selling tan and gray interior pieces out of my 97 GSX I have majority of all the interior panels including seat belts, center console, etc.I prefer local sale on these only. I don't have time to pack and ship things at...
Since my idle increased after installing these I'm almost certain this was the reason lol. Fully warmed up my idle is around 1500, prior to install my idle was probably around 800. Could this also be due to my blown turbo though? I'm thinking about leaving the FP exhaust manifold on but changing...
So my gsx has felt sluggish since getting it but seemed stout. It's a 2.3l stroker so figured the 14b that's on it was a little weak for it, I changed out my stock manifold and intake to FP and that didnt make any noticable changed. Other then my idle being a little higher then before. However...
What’s up everyone new to dsmtuners ive owned my car a little over a year now its a 95 gsx auto with hx40, i got the car with a bad trans got a used trans and it started leaking from every seal possible, so it sat for ~8 months and im upgrading from ecm link v2 to v3 going flex fuel and speed...
So I picked up the 1997 GSX today about 2 hours ago. I will go through tomorrow and do a thorough build update and take more pictures.Really happy to be back into the DSM game. A few things I need to solve is the check engline will come on flash a few times then go away when cruising at 60...
Been a long time since I have been on here, but I recently just sold my 2004 WRX STI. I am looking to get any manual AWD DSM that's in decent shape.I have been chatting with a guy that's about 6 hours away. He has what seems to be an overall good condition 95 talon TSI. It has just under 190k...
Alright so I picked up a 1995 GSX a couple weeks ago. But I need some help from y’all since I’m new to these engines. I bought it running perfectly fine. One morning I started it up and 30 seconds later it shut off. Started it again same thing. Now all she does is turn over but won’t start. I...
I have a 1990 GSX. I'm confused about the whole shimming/fork vs syncros thing.My 1st gear grinds while rolling almost all the time, unless I go super super slow. At a complete stop it is fine. 2nd grinds below 4k rpm. I have a little bit of play from shifter bushings I presume.At first...
Been doing a some work on my '96 gsx (timing, water pump, crank/cam front seals, etc.) and while turning my crank to align the timing marks and it wasn't really difficult to turn by any means but the was more resistance at some times than others. I have all the spark plugs pulled but I have the...
I have a complete white 91 Eagle Talon AWD Automatic 2.0 Turbo.
It has major rust issues on the button side of the body and frame. Unsafe to drive in my opinion. Too much to repair!!
Gas tank has been removed but I still have it, with repairs done to tank and pump.2nd car: Orange 90 Eagle...
I have been in the market for a turbo eclipse for a while now since I've owned 2 already and loved them and I decided to post this to hopefully get some help. I have cash on hand for an eclipse somewhere in the 3k-5k area. Just needs to be rust free-ish and not a total project car. I also have a...
Hey soI sold my 1995 gsx I started building when I was 15 (couldn't afford parts) and I just found it and i'm buying it back and have the money to build it now. Im shooting for 600hp and want help knowing what parts to buy don't wanna buy every single top of the line part but don't want cheap...
For sale a 98 GSX 5 speed rolling shell rust free. I hold a clean title on hands under my name.It was a Florida car then North Carolina, car was never exposed to salt, no rust.
Shell comes with new brakes, driller slotted zinc plated rotors, new pads.
Hand brake is working great. Brake system...
Looking for a 98/99 Eclipse GSX in one of the following colors:1. Barcelona Red Metallic
2. Magenta Gray Metallic
3. Monarch Green Pearl
4. Summit WhiteLooking for an automatic.Would prefer as close to stock as possible, this car WILL BE A DAILY, stored during the winter.MUST BE RUNNING...
Hi,I am looking for a clean, mostly stock GSX or GS-T manual. I am not picky about color, but I am picky about condition. Willing to travel just about anywhere to get one. My budget it $5k. This is the car I've wanted since I was 13 and I finally have the resources to do it. I look forward to...
I'm selling a nearly perfect 100% replica decals of the OEM GSX, GST and MITSUBISHI rear decals. I happened to buy a couple of these decals almost 10 years ago and wanted to have them re-made.Everything else currently available is not perfect, and 100% of the others available are individually...
While in the process of helping my cousin do a head gasket and timing belt replacement, a live wire touched the ECU and left some burn marks on its cover.
We essentially want to know if anyone who owns a 97 gst or gsx and lives in the Inland Empire would allow us to plug in our ECU to see if...
I am in San Jose CA, I just listed this car for sale on craigslist SF bay areaVery rare, 1998 Eclipse GSX in very good condition.I put $3,000 of maintenance work into this car in the last 12 months, and drove less than 2k miles since.New front tires
New front axle
Good rear tires
New...
hey not sure if this is the right section to post on as it is my first time posting here. little back story on me. i mainly started on cars by doing body works.i recently got into mechanical stuff. i bought a eclipse gsx clean 1995 66k mileage for 1400. car ran rough as it had 6 years old fuel...
$1,500
On on op
Clean title
133,000 ish miles
Located in Northern California
4g63t engineUpdate: I rebuilt the car, it ran fine at first, but after about a week later I didn't notice I was running on low coolant and was overheating the car. It later started blowing white smoke out the pipe...
Looking to buy a rust free gst,gsx, or tsi shell I just built an engine that is very clean and I'd like to start it this summer I live in Minnesota so if you have one around let me know my number is seven01 936 five563
1993 Eagle Talon TSI, Automatic transmission, all wheel drive.
Original owner in his 60s. No check engine lights and has transferable Pennsylvania antique license / registration plate. Does not need to be inspected due to the antique plate.Solid body, very nice interior. Power windows and...
Hello I'm looking for a 2g eclipse gsx prefering it to be around somewhere around NC but can travel to SC, needs to be in running condition with AC and heat, no rust and we'll taken care of
hi guys ive been looking for an eclipse to buy for a while n I wanna learn how to work on it and tune it up n i was wondering if anyone in the ie oc or la county have a gsx or gst with good miles that they wanna sell if you got anything leave a number or lmk on here thank you
so i just bought a rolling shell from someone and they said it had a 4g63 with a turbo in it. now they are saying it might not have been a 4g63 and might have just been a gs. the engine is gone and all parts are striped is there any way i can tell from engine bay or anywhere on the body weather...
I have a fresh 2G auto GSX Transmission including all related parts (CV axles, driveshaft etc) make me an offer on something you need. There is nothing wrong with any of the parts, I bought it for the engine. Text only please @ 475-235-7841 Parts are located near Augusta GA, I am willing to...
Anyone know if the rear lower shock mount on a 2g gsx is available to buy somewhere? Its the mount the goes into the knuckle then the shock slides onto it then the 17mm bolt threads inside of it.