Will this Map sensor work for my new speed density setup?

[gtrej01]

I am new to speed density and am trying to get my car setup with speed density.

I was told I needed a map sensor and remembered I had one laying around from a electric boost gauge I had. I believe its a gm 3 bar map sensor.

Will this work for speed density?

Thanks for any help in advance.

 

[snowborder714]

Yes.
externalsensorlist [ECMTuning - wiki]

 

[gtrej01]

Yes.
externalsensorlist [ECMTuning - wiki]

Thank you for the quick reply. Very much appreciated.

 

[gtrej01]

One more quick question?

Ive been told it is not necessary to run a AIT sensor with speed density. Is this true?

 

[PrimerPLus]

Yes that's true. But I found on ecmlink forums they have writeup and it says its recommende to run the iat.

 

[gtrej01]

Yes that's true. But I found on ecmlink forums they have writeup and it says its recommende to run the iat.

Ok, I spoke to the guys at English racing and they stated I would not need a AIT sensor. Figured they knew what they were talking about.

Im just trying to get it all setup and running to drive it in for a tune, I like to do most of the work if im able to reduce the cost of my build, Thanks

 

[snowborder714]

I believe English usually tunes without the IAT. Either way you're fine, just know that the IAT adds a bit more to the tune to get it dialed in better. But I've seen cars tuned fairly well without using it.