T3 Turbine housing measurements please

[Archer Fabrications]

hey, someone would save my life if they measured the largest OD of the turbine housing, from the outside of the flange, to the farthest point of the curl it would be very appreciated. please .70 or Larger, larger the better, pictured is FP.s .85AR

You must be logged in to view this image or video.

 

[dustyboner]

6 7/8" on a Garrett .82

7" on a Schwitzer divided T3 ((borg warner s200) i don't know what the exact AR is, it just has 193 on the inside of the inlet. but its bigger than the garrett

 

[Archer Fabrications]

thank you so much! and that 6 and 7/8 was from the outside of the flange right? not the back of the housing?

anyone have measurements on that FP .85 also?

 

[dustyboner]

yup from the end of the flange.

i used a small L-square like:

You must be logged in to view this image or video.

 

[Archer Fabrications]

THANKS SO MUCH!

 

[Archer Fabrications]

Anyone hbe measurements of a bep .70 housing? I believe the castings are a little larger

 

[lasthope05]

Is that my picture?

::Edit::
Just went out to the garage. 7 1/2" from flange to rear.

 

[Archer Fabrications]

Is that my picture?

::Edit::
Just went out to the garage. 7 1/2" from flange to rear.

I think i just got it off google it could be, i didn't really check where it came from, 7 1/2 is effin huge, thats how big my divided t4 is.. Are you giving measurements foe the fp .85?

 

[lasthope05]

Yup.

 

[Archer Fabrications]

Yup.

It's a nice lookin turbo