Post your 1g install pics

[thekellbeast]

You could try mounting the solenoids down on the backside of the block, underneath the intake manifold. I don't know how much clearance there is on a 1g.

 

[JOEY A]

Im going to be getting a Wet kit for my 1G, to many sissy on here dont like to spray.


Anyone have a hidden kit? Ive go a few places and ares ive seen that could be used.

 

[AuntiesTSI]

here you go. cant see it under the intake. i made the distribution blocks myself.

That thing is SICK!! How much would you charge to do one sometime for me, .

 

[sheldon]

Zex wet kit install. I ran the fuel supply off the regulator. I also routed the purge to the intercooler...

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

 

[DSMcamaro]

Zex wet kit. should get my little 14B FWD into the 12's.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

 

[twack]

new toy

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

 

[KGB Pilot125]

Does anyone have pictures of a hidden install. Im thinking if going with a direct port kit and running a 150 shot on a built 2.3L engine and GT35R and controlled by EMS.

The problem I run into is that everything must be hidden because here in Canada, Nitrous is illegal on a street car. I was thinking of cutting a big section of foam from the back seat cushion and then cutting the sheet metal and creating a box that would sit lower. Running the nitrous under everything. The problem I run into is the engine bay. How would I make it so that NOTHING shows.

If anyone has any pictures it would be extremely helpful, along with any advice.

One of my friends cut the bottom out of a medium sized duffel bag and just put it over the bottle in his SHO. another set up is to cut out the bottom of a small tool box and have it in there.

 

[turboglenn]

I did theh duffle bag trick in my mustang. I just bolted the mounts right throught the bottom of it. Then to hide teh rest i covered all the braided lines in black wire looming. I put the nozzle on the underside of the TB inlet to where you could barely see it. Most people couldn't tell untill i was passing them sideways in third gear