1G Need help with wiring ATX to MTX swap

[vetexr]

I recently bought a 1991 Eagle talon tsi awd, originally auto but previous owner swapped a manual trans in it and didn’t finish, i ran into the NSS problem and wont turnover only clicks, I’ve looked through forums and service manual but cant find how the plug for the NSS looks like, and if anyone knows which 2 wires i connect from it to bypass the NSS it would be great to know.

 

[19Eclipse90]

Check posts #4, 6, and 10 here: Auto wiring harness, 5 speed trans, POSSIBLE???

 

[92AWDHX40]

I've just did this project.

 

[vetexr]

Check posts #4, 6, and 10 here: Auto wiring harness, 5 speed trans, POSSIBLE???

Thanks! it worked, i put a wire between plug 8 to 9 and it started cranking when i tried. But on another note i read somewhere that one could also use the speed sensor from either the same plug or the one next to it, do you know anything about that?

 

[19Eclipse90]

To accomplish what?

The vehicle speed sensor does not play a role in the starting circuit. The wiring diagrams for the starting circuit are available here: Stumped on No-Start (No Crank)

 

[vetexr]

To accomplish what?

The vehicle speed sensor does not play a role in the starting circuit. The wiring diagrams for the starting circuit are available here: Stumped on No-Start (No Crank)

Oh sorry i meant the reverse light switch

 

[19Eclipse90]

There is some rewiring to make the reverse lights work with the manual transmission's switch, if that's what you're referring to; see: Reverse light connector question