2G How does this hone job look

[Jonnyeclipse]

So here is the third gear pull. I thought it looked safe enough so I did the motoman breakin with this tune. Now I am trying to fine tune. I also drove to and from work with no problems.

 

[1990TSIAWDTALON]

Its a busy day today at the office. I will try to take a look at it in a bit
I had the log up but didn't see any "pull".
Make sure you loaded the right file. This one is all idle from what I see.
Double check that.

 

[Jonnyeclipse]

Its a busy day today at the office. I will try to take a look at it in a bit
I had the log up but didn't see any "pull".
Make sure you loaded the right file. This one is all idle from what I see.
Double check that.

Thanks Marty. I checked the log I attached and it is the correct one. It’s only less than 30 second clip. I will post the entire log instead of just a clip.

 

[Jonnyeclipse]

Here is the full log. Thanks again

 

[1990TSIAWDTALON]

I'm on my phone but I'll grab the laptop and look to see if something sticks out to me.

 

[1990TSIAWDTALON]

Are we on gas or E and MAF or SD John? Looks like E
I don't see a reason why not to increase timing. No knock apparent. Grab the sliders for timing and add 2* across the board after 3k. If it hates on you or the knock sensor flickers,, get out of it and don't exceed 15* max for now.
I smoothed out your SD table and attached it.

 

[Jonnyeclipse]

Are we on gas or E and MAF or SD John?

Thanks for taking a look. It’s clean fresh 94 octane pump gas. It is running SD.

 

[1990TSIAWDTALON]

Better SD table here. much smoother. If you load one, use this one.
You caught me at the right time, we are tuning a Holley EFI V-8 setup right now too.

 

[Jonnyeclipse]

Better SD table here. much smoother. If you load one, use this one.
You caught me at the right time, we are tuning a Holley EFI V-8 setup right now too.

Thanks Marty. Holley, doesn’t that do full time wideband closed loop? That would be awesome. Thanks for the table. I will take a look and load it in. I need all the help I can get. I am pretty sure the rings seated. I went from 145 psi on all 4 to 195. Appreciate the help.

 

[Jonnyeclipse]

Took me a while but I got in some more tuning. I loaded Marty's SD table and made a few pulls. I did change my global less - to get the WB and afrest closer. Still a long way to go.