2G Fic injectors radium rail

[Bedicine]

Hello

Was curious if anyone is running 2150 injectors or something similar in size with a radium fuel rail. I’ve been speaking with FIC and radium trying to find a solution but I keep having the injectors leak as the rail can’t get close enough to the head (photos attached) which puts them at an awkward angle when tightening down but was told it should fit.

I have an fic rail and don’t have an issue since the spacers are larger

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

 

[MindBlowin03]

I have FIC 2150s with a Radium rail without any issues.

It looks like you might be missing the spacers from the head to rail.

 

[Bedicine]

I have FIC 2150s with a Radium rail without any issues.

Are you using the top or side feed rail? Do you know what rubber you’re using, wonder if my set is too tall

 

[MindBlowin03]

Are you using the top or side feed rail? Do you know what rubber you’re using, wonder if my set is too tall

Sorry, I edited my last post. You are missing the spacers.

 

[Imback]

Your missing the fuel rail spacers. I would also loctite the the allen head bolts once they are installed with the correct spacer since they have a tendency to vibrate out. I have the rail on my car as well as installed it on a friends 2g with no issues. You can 3d print the spacers if you lost the original ones or you can but them for a few bucks new.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

 

[Bedicine]

Your missing the fuel rail spacers. I would also loctite the the allen head bolts once they are installed with the correct spacer since they have a tendency to vibrate out. I have the rail on my car as well as installed it on a friends 2g with no issues. You can 3d print the spacers if you lost the original ones or you can but them for a few bucks new.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

I didn’t get any spacers with the rail that I can see and bought the injectors used. Would FIC sell them? I do have a printer I could run them out of petg worst case

 

[Justin DuBois]

I didn’t get any spacers with the rail that I can see and bought the injectors used. Would FIC sell them? I do have a printer I could run them out of petg worst case

The spacers are the original stock spacers. Radium assumes you have those - I don’t think they sell them.

 

[Bedicine]

The spacers are the original stock spacers. Radium assumes you have those - I don’t think they sell them.

I never had them as my car was an empty shell.
I found this file I Can do in petg then but then with some high heat paint

You must be logged in to view this image or video.

 

[Justin DuBois]

I never had them as my car was an empty shell.
I found this file I Can do in petg then but then with some high heat paint

You must be logged in to view this image or video.

check the dimension - It is not unusual to adjust spacer thickness to suite the injector seals.

 

[19Eclipse90]

3D Part Files

 

[Imback]

The link above is perfect. But this would be a great modeling excersize since it's a relatively easy part to model. Good luck.

 

[miliman13]

I never had them as my car was an empty shell.
I found this file I Can do in petg then but then with some high heat paint

You must be logged in to view this image or video.

Those are not the spacers you are looking for

You must be logged in to view this image or video.