9 counts of knock no matter what

[90_talon_matt]

mods are: 9:1 compression, hks 272/264, ported head, ported 14b, mbc set at 13psi, stock fuel system accept for pump rewire. no matter what if i'm on the throttle slighty or at WOT i get 9 counts of knock. my timing advance was previously only hitting 8* but i adjusted my base timing to 7* so now i peak out around 15* at WOT around 7 grand. My o2s were at .8. Sorry i couldn't post the entire log i haven't been able to figure out hot to get it onto the comp from the palm. Any suggestions as to why i knock 9 counts regardles? Any help would be great thanks

 

[4gsx63]

mods are: 9:1 compression, hks 272/264, ported head, ported 14b, mbc set at 13psi, stock fuel system accept for pump rewire. no matter what if i'm on the throttle slighty or at WOT i get 9 counts of knock. my timing advance was previously only hitting 8* but i adjusted my base timing to 7* so now i peak out around 15* at WOT around 7 grand. My o2s were at .8. Sorry i couldn't post the entire log i haven't been able to figure out hot to get it onto the comp from the palm. Any suggestions as to why i knock 9 counts regardles? Any help would be great thanks

My bet is either your knock sensor needs to get replaced or knock sensor wiring harness is not connected properly. Good luck!

 

[Nos~4G63]

Set the base timing to 5degrees btdc. When my knock sensor was unplugged I constantly had 7counts of knock.

 

[90_talon_matt]

hmmmmm i'll check the wiring. i know the sensor is good because i changed it in the summer when my motor was out and i was building it. It's a good possibility that its the wiring the motor's been out twice since the rebuild :thumbdown go figure eh....oh well its all fun and games thanks very much tho. does the timing advance and o2 voltage look ok though?

 

[5150DSM]

Knock sensor not plugged in or wires cut. 9 counts is the "default" value for the computer if it reads "no input" from the knock sensor.