TheFlashDSM
Supporting Member
- 1,106
- 356
- Feb 18, 2010
-
stony brook,
New York
i just picked up a 1g "built" head from my buddy, claimed was fully build, annd it is as far as from what i see, it was ported smooth on both intake and exhaust runners and bc springs and retainers and also revised 3g lifters, also claimed +1mm intake and exhaust valves,
my question; what brand are these valves? they measure int. 35mm and never got the intake out yet so i still gotta measure that
answer with number to match question,
1. what brand valves
2. if i re use them will they hold 800hp (re use by re lapping and cleaning them with brass wire wheel) to look like in the pic
3. should i use them (yes-no)
4. what brand valve will hold 800hp
my question; what brand are these valves? they measure int. 35mm and never got the intake out yet so i still gotta measure that
answer with number to match question,
1. what brand valves
2. if i re use them will they hold 800hp (re use by re lapping and cleaning them with brass wire wheel) to look like in the pic
3. should i use them (yes-no)
4. what brand valve will hold 800hp
You must be logged in to view this image or video.
You must be logged in to view this image or video.
You must be logged in to view this image or video.
Last edited:
