bmxfelon420
20+ Year Contributor
- 652
- 62
- Sep 6, 2005
-
Napoleon,
Ohio
Hey I did read a bit about this on the forum but all the threads were really old so I didnt want to bump a dead thread for this. Basically I was just thinking, if I set up the wiring for the clutch cut but instead wire it to a toggle switch, can I just set the rev limit for it to a low amount as a sort of valet mode? In the off chance I ever need someone to drive me somewhere i'd like to be able to set it to 3k or so just for safety. Would that work like I think it would?
