Syclone turbine housing flange

[sqr]

I am looking for a down pipe flange for the t3 Syclone turbine housing. Forced Performance Turbochargers: Syclone/Typhoon 8CM Turbine Housing I can't seem to find one.

Thanks for your input.

 

[RvlutionMtrsprt]

Try atp turbo, then hahn racecraft if they don't have it.
Here it is from hahn:
http://www.turbosystem.com/hahn/parts/install.htm
I'd still check with atp.
http://www.atpturbo.com/mm5/merchan...tp&Product_Code=ATP-FLS-018&Category_Code=FLG

 

[JusMX141]

It's just a 3-bolt triangular flange- get some specifics on the bolt pattern and do a little research with various exhaust manufacturers to see what they have to offer.

 

[sqr]

Thanks for the leads.

 

[GDNF2ET]

Try this forum..
SyTy/SGT - Forums - Powered by vBulletin

 

[sqr]

I ordered part # H TZ-7305 From Haha. The guy pulled the part and measured it. It fits perfect. It is 1/4" thick. I would have rather had 3/8 though. I did not call atpturbo.

Price was $23.13 shipped.

 

[Kevin Jewer]

I'm a little late on this, but for the archives, NAPA sells a flange and gasket that I've made a few downpipes from. 2.5" center hole, 3 and 3/8ths bolt spacing IIRC. Cheap, and local. It's also pretty thin.