Rear ones in progress also!! Will be able to do oem 262mm, Evo 300mm and Evo X 330mm!Just waiting on cut samples of the front cooling duct brackets for.
oem knuckles/brakes.
galant/brembos.
my calipers I offer.
Little update on this to move it forward a small bit.I had some rotors machined for the center bore for the 300+320 but when i received them i was not happy about the weight ( i did opt for thick rotors ) these came in at 9.7kg! Heavy buggers...
Bad news and good news...Bad news is that we're no longer going to offer our 2G front LCA group buys.
Good news is that it's because these have become a shelf-stock part number that you can buy off the website. Yay, finally! We have only 7...
Well we are able to grab a decent inch-pound torque wrench off FB Marketplace locally and get things properly installed. To start we got the necessary gaskets ready to go.The front case gets torqued to 17 ft-lbs (or 204 in-lbs).Since we're...
Im all good dude but thanks. I got my friends awd and my fwd here so between us I should be able to compare what will work with both to simplify it all.I shall do my best to get this all done.
It will fit under a 17" wheel fine and wont be any worse off then the front calipers i do currently so it will match with what ever wheels are currently used to not have to stagger wheels.Everything will be rebuildable of course. I wont make...
Never a dull moment when you show up that's for sure LOLIf people wish to keep oem calipers they can do but this is NOT the place to discuss that! I'm after HELPFUL insight and feedback not what you always give which is pretty much negative all...