Resurfaced flywheel

[jpmxrider489]

I recently got the act streetlite flywheel and got it resurfaced. The guy that did it said it was resurfaced before. He also said he wouldn't do it again after this. I told him the specs and showed him rre page. He said its within spec and I shouldn't have any issues. He also didn't want to measure in front of me. Now what I'm worried about is putting it on with the unknown. I don't have the tool or know anyone else. It does look like he did resurface everything that was needed.

 

[OGDSM1989]

Digi-calipers can be had cheap from any parts store. They are a good tool to have around ..... and then you can have piece of mind on the specs

 

[pauleyman]

Calipers are not the right tool. It will not work. A depth mic is the proper tool. I won't leave the machine shop until they measure in front of me.

 

[jpmxrider489]

Just got my flywheel measured in front of me and one spot was.608 and another was .610. So I would assume thats fine. Also has anyone heard of marking the spot you take it off to put the new one on?

 

[pauleyman]

If you were using a depth mic across the pads that is not acceptable.