Removing axels on '90 AWD

[BOOSTIN21]

i have all the necessities ou tof the way i am writing this from my autos class right now. the fluid is drained out of the tranny the linkage is out of the way and the clutch line is out of the way.
(do i need to press the clutch to get more fluid out?)
i know i need to take the studs and 2 huge nuts off the strut but where do i go after that? i need assistance please and if i missed anything along the way let me know i am doing this off of knowledge and no instructions. i am just removing the tranny so...
i know i need to unbolt the T-Case from the tranny and the mounts and unbolt the tranny from the motor

 

[AWDgsx905speed]

After that wiggle the half shafts free from the wheel bearings. There are two bolts on the driver side half shaft for the carrier bearing. I believe the driver side half shaft has to come out first. Then you have to remove two crossmembers on the passenger side under the tranny. I can't remember after that but look at VFaq.com under drivetrain for the rest.

 

[BOOSTIN21]

cool thanks i will do that as soon as i get to my autos class tomm. and i will check out vfaq.com right now