My 420a Turbo Manifold (Part 1)

[OblivioAssebit]

This is the merge pipe I made this weekend. I'm waiting on some more elbows so I can start on the runners.

 

[1kwik4g]

damn that is looking good.Is that piping you are using, thick enough for boost?

 

[OblivioAssebit]

Yeah, its schedule 10 304 SS. I will only be pushi 12 lbs max through this. If i go any higher ill move up to schedule 40.

 

[vinnio]

well... you weld better than I do, its official. Those seams are clean!

 

[pj91gsx]

well done is that turbo flange the size of a 6 cm housing or a 7 cm housing inlet? well done either way.

 

[OblivioAssebit]

You know... I'm not 100% sure but i'm pretty sure its a 7cm housing. I'm going to do a write up so everyone can see how to make these. Honestly if you have the tools (or know someone who does) and your not a complete moron its not too hard to do. Check in the Custom Fab forum.