ISC and BISS questions

[Ivan Magbojos]

sir im newbee here, ill just clean my whole intake system last morning.. then after all my engine hesitating then check engine comes on... all sensors and wirings are connected.. i used paper carbon gasket maker for the intake manifold gasket and tb gasket... can you give me some advise or picture of proper positioning of air idle adjuster screw and throttle body positioning ing my throttle body? i have 4g63A 2.0 16 valve.. hope ill get some advice... thanks a lot sir!

You must be logged in to view this image or video.

 

[XC92]

Welcome to the site! To get a proper response you should create a new thread and include as much info about your car & situation as possible, e.g. year, model, trans, auto/man, turbo/non, etc. Also explain what is specifically happening, at idle and when you rev the engine, etc. Your post is too generic to be able to help much.

 

[jpmxrider489]

Check out this link. Good input.

https://www.sixsigmatuning.com/dsm-idle-control

 

[spyderdrifter]

Intake manifold gasket should be metal instead of paper.