Intake hoses/vacuum lines

[Teflon]

Ok, I was pulling my heads off and it started to rain. I already had the heads on the engine hoist and couldn't get them back down. So I did the stupid thing and pulled them off faster without labeling or marking all of the lines and hoses behind and on the intake manifold and throttle body. I also ripped a few, But I have replacement hoses. Now I can't figure out where they go back to. I tried looking in my Haynes manual and in Vfaq and I haven't found anything. Can anyone help me out by posting a diagram or a picture of yours. Or explaining where they go. I also think I broke a sensor back there too. I can post picture later if you need them.

 

[nlzn]

I've removed a lot of un needed lines from the intake manifold/throttle body and capped them. I can get you a pic of which lines ive capped off if that'd help.

 

[Teflon]

That would help a bunch, I just got some pictures of what is disconnected I just need to get them on my comp.

 

[snowborder714]

http://www.dsmtuners.com/forums/art...-speed-shop-vacuum-diagram-removal-1g-2g.html

 

[Teflon]

You are my hero.