Innovate mtx and v3 lite

[VisionPaintball]

My gauge and logged afr dont match. At idle the gauge says 14.8 and ecmlink says 15.4.

Any suggestions?

Thanks

 

[snowborder714]

Did you split one wire and run it to both the gauge and the ECU? Or did you reprogram the brown wire to read 0-5v?

 

[Dsmkauai]

We talked alittle about it here. http://www.dsmtuners.com/forums/tuning-engine-management/394157-mtx-l-ecmlink-any-users-yet.html. If you should need anymore help repost or pm me. You won't get it to log and read dead on because I believe link is alittle slower, but you can get close. Hope that helps bro.

 

[VisionPaintball]

Did you split one wire and run it to both the gauge and the ECU? Or did you reprogram the brown wire to read 0-5v?

Neither. All I did was connect the yellow wire to egr temp sensor of ecu.

 

[Dsmkauai]

That all you need to do is run the yellow for wideband into what ever input you choose. Since the gauge is the controller it's already wired to it.

 

[snowborder714]

Der

 

[VisionPaintball]

Does your mtx and link have the same readings?