Yamahaulin
10+ Year Contributor
- 695
- 12
- Jan 30, 2010
-
Bowling Green,
Kentucky
Are you guys using the factory defaults on the output settings? I am trying to use the simulated narrow band instead of my factory sensor so i have the yellow wired to the front 02 on the ecm. I am using the brown wire for logging wideband in dsmlink so i have it wired in the rear o2 position. Somethings not right the car will not go to closed loop the front 02 is not switching. Best i can tell the ecm won't read a voltage higer than 1.1 so i figure i need to rescale the wideband at least. The narrowband seems like the scaling is correct, but i'm having trouble. I think my problem lies in calibration, i don't have a LED light so i'm not sure if the calibration worked.
Last edited:
