4G Power
10+ Year Contributor
- 76
- 0
- Sep 20, 2012
-
N/A,
Missouri
Hey everyone, I've recently replaced my Innovate LM-1 with an Innovate LC-1! I found a pretty good deal on it on craigslist and thought i'd pick it up! I just have a few questions though;
1) On install, is it necessary to ground the white wire to ECU Sensor ground pin 92? I just grounded it wherever, in a different spot than the blue wire. (referring to this thread http://www.dsmtuners.com/forums/art...21002-innovate-lc-1-installation-options.html )
2) As I purchased this used, it came with basically everything except the cables to connect to my laptop. (to setup with the CD program) It does have two cables that I believe are input/output, but it's missing the ones that I plug into there, that then plug into my laptop. Where can I get these missing cables?
Thanks!
Anyone?? I would like to figure this out ASAP
1) On install, is it necessary to ground the white wire to ECU Sensor ground pin 92? I just grounded it wherever, in a different spot than the blue wire. (referring to this thread http://www.dsmtuners.com/forums/art...21002-innovate-lc-1-installation-options.html )
2) As I purchased this used, it came with basically everything except the cables to connect to my laptop. (to setup with the CD program) It does have two cables that I believe are input/output, but it's missing the ones that I plug into there, that then plug into my laptop. Where can I get these missing cables?
Thanks!
Anyone?? I would like to figure this out ASAP
Last edited:
