HKS turbo timer type-1

[DSM_GSX01]

My turbo timer is beeping on and off when i drive my car. I dont know what the problem could be but its hooked up right i checked twice. When i turn the car on it will start beeping when i drive it or if I just turn the car on with engine off? I haven't found any forum on this. Any help is great thanks.

 

[silvreclips]

Does it start timing down or just beep? Mine has always worked perfect, I know you said its wired correctly but I would start there if its not working correctly.

 

[DSM_GSX01]

It dont start a count down when i shut the car off it just shuts off. And if the cars on it beeps like its counting down. It also does this when i drive. I checked all the wiring and diagrams again. I dont know what this problem can be.


Also how did you hook your turbo timer up?

I just got back in the house from outside and looking at my RPM signal wire and speed sensor wire. I looked at the instructions i used and that came with the turbo timer and i think they might be wrong. But the RPM wire is hooked to pin 4 on the ECU. And the speed sensor is hooked to pin 7 on ECU.

I uploaded a picture of the pins i hooked up.

 

[silvreclips]

Try looking up an ECU pinout for your ECU, that will tell you if the instructions are correct or not.

 

[DSM_GSX01]

Ok i will do that to make sure. Do you know of any websites i can look on?

I found a pin layout on here. My picture from my HKS turbo timer matches the ECU layout i think. I am sure i double checked and also had a friend check. He said it looks good. Do these look like the right pins? Also let me know if it matches my picture i posted before in the picture above. Thanks.

pin 89 is the Crankshaft position sensor. A blue/white wire.
pin 86 Vehicle Speed sensor.A yellow wire.

 

[DSM_GSX01]

Help on this post i have checked wires again?

 

[FIBA M - EC17PSE]

I have this timer and mines fine. Did you connect the correct hand brake wire to the switch under the center console! Its been such a whioe since i did this i dont remember alot but im oretty sure the silver wire/grey is for the hand brake. Mine worked perfect first time even hooked upto the ecu.