Head install

[algomni]

I cant seem to find anywhere the correct head bolt sequence for a 7 bolt. Also The paper ARP sent with the studs says I should torque them to 80 ft/lbs. Other people, while I was searching for the sequence, said to torque them to 100 ft/lbs? I'm assuming I should follow ARP's recommendations and do the 80 but I thought I would go ahead and throw that question in there, thanks in advance!

 

[bostinhitmeup]

You should go with the torque spec that ARP provides

 

[95mitsubGSX]

Go with the torque spec Arp gives you. The torque sequence for the head bolts is in the Chiltons manual.

 

[BogusSVO]

http://arpinstructions.com/instructions/207-4203.pdf

This is for the 94 and up 4g63

Standard ARP 11mm

The pattern you use is from the center out in the criss-cross

 

[Archer Fabrications]

Theres different torque spec depending If you use molly lube or motor oil.