General GM omni 4 bar on 6 bolt questions

[OutlawPNW]

Hey guys, last year i purchased a unfinished GST build to bring back to life, I’m going to install my GM style Omni 4 bar map sensor, my car doesn’t have a MAP in it yet. I’m told that this plug in this photo I provided that is not plugged in is the MDP and to cut it to wire my new map sensor, is that correct? If so, my map sensor has a red, blue, and black wire, but the sensor on the car has a green with light green stripe, and a green with black stripe, and a black. I’m trying to figure what color needs connected to eachother.
Also if I’m just wait off, please help a brotha out, lots of quarantine time I’m trying to get this sweet car out there on the road again and I’m learning every step of the way.

 

[DSMPT]

You can use the MDP connector if you have ECMLink or so.
MDP Green/Yellow - MAP Red
MDP Light Green/Black - MAP Blue (Or the middle pin)
MDP Black - MAP Black

 

[OutlawPNW]

You can use the MDP connector if you have ECMLink or so.
MDP Green/Yellow - MAP Red
MDP Light Green/Black - MAP Blue (Or the middle pin)
MDP Black - MAP Black

thank you so much! I do have ECMlink i just got dsmlinkv3