2G EGR, EVAP, and FPR solenoid bracket bushings

[Justin DuBois]

I'm looking for new rubber bushings for the firewall brackets. Can someone point me at a source?

Thank you
Justin

 

[MacMarty15221]

(Yet another thing we could cast or 3D print, if we had one instance to take measurements from.) @Justin DuBois, do you have part numbers from the part catalog?

 

[Mello]

I looked quickly and did not see the little rubber bushings with the aluminum sleeve listed as a separate item, I did find the solenoid & bracket assemblies though. You might be able to find generic electrical wiring wire grommets and some aluminum sleeves (may be McMaster) and rig up something. I don't think rubber is being 3D printed presently either.

You must be logged in to view this image or video.

 

[Justin DuBois]

- posted similar times... I found the same

https://www.dsmtuners.com/threads/2g-eagle-talon-and-chrysler-sebring-dodge-avenger-factory-parts-catalog-1995-1996-1997-1998.517693/

Parts catalog has related parts
MR12 6454
MB92 4421

But I could not find a rubber specific item.

 

[Justin DuBois]

You must be logged in to view this image or video.

You must be logged in to view this image or video.

 

[19Eclipse90]

I would be doing some research for grommets, as suggested. You know the bolts going through them are M6 so that’s a start!

These are just a few results that I thought were close and a little outside of just a regular wire grommet. Did not investigate past the through hole being large enough for M6 bolt and generally being of the form those bushings are:

MiSumi RF7023L2
McMaster-Carr 6309K61

 

[MacMarty15221]

..... I don't think rubber is being 3D printed presently either.

Well, it depends on what you mean by "rubber". There is a flexible 3D printing filament called TPU, melts at 250* C, which is 482* F. Hopefully the firewall doesn't get that hot. TPU is perfectly suited for applications like vibration isolation. @Justin DuBois, if you can send me one original of each part (shape), I will print you up a complete set at no charge. PM me if interested.

 

[curt-s]

may be time to find a hose of the same diameters and make one..?

 

[MacMarty15221]

@Justin DuBois, "This may be the droid you're looking for." LMK.

Found this bushing and brackets in my 1Ga Eclipse, part of the half-deleted EGR system. Bushing is foam rubber, bore is 9mm. OD is 23mm, overall height is 16mm.

The tubular sleeve on the left side of the bracket (photo 2) is 9mm OD, 7mm ID, so a logical fastener in this case would be an M6 x 22. Firewall bracket has captive nuts. Mounting hole for the bushing (photo 1) is 14mm.

You must be logged in to view this image or video.

.

You must be logged in to view this image or video.

.

You must be logged in to view this image or video.