The Central Hub for DSM Community and Information

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. This is where the DSM platform history is documented and archived. Log in to help us in our mission, and to remove most ads from the browsing experience.

Post a Question

cylinder walls

Please Support Fuel Injector Clinic

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

SilverEclipse96

Banned Member
112
0
Jul 17, 2004
chi, Illinois
Recently did a cold compression test (car does not start) and got 65-70 across all 4. Afte pouring a cap full of oil the compression went up 15psi across all four.

My question is do the walls look good ?
 

Attachments

You must be registered for see attachments list
Sort by date Sort by votes
I have seen worse.

The cross hatch is about gone.

Mic the block for wear, if it is decent hone it, new rings and bearings and go on with it.

If it has alot of wear, bore .020 get new pistons and rings and carry on
 
Upvote0
Add Value - Be Respectful - No Trolling - No Misinformation - Participate Often!

Similar threads

  • Question
rusty cylinder walls
Replies
1
Views
670
95 'clipse RS
95 'clipse RS
dan2288
  • Question
boring my cylinder walls
Replies
7
Views
839
Eclipsethis90
Eclipsethis90
boosted86
  • Question
Piston slap+cylinder walls+honable?
Replies
5
Views
8K
BogusSVO
BogusSVO
AlmightySo
  • Question
1G Surface rust on cylinder walls :(
Replies
12
Views
2K
AlmightySo
AlmightySo
SkinnyBAM
  • Question
How can i clean this crap off my cylinder walls?
2
Replies
27
Views
2K
steve
steve
Boosted Fabrication
ECM Tuning
ExtremePSI
FIBA Motorsport
Fuel Injector Clinic
Innovation Products
Jacks Transmissions
JNZ Tuning
Kiggly Racing
Morrison Fabrications
Rix Racing
RockAuto
STM Tuned
Support Vendors who Support the DSM Community

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds

Back
Top