AEM wideband and Pocketlogger

[black92_tsi_awd]

Has anybody used the output from a AEM 6-in-1 Gauge-Type Wideband UEGO Controller to log through the Pocketlogger. Any compatability issues? Will the offset function take care of any value differances?

Just looking for info before I make the purchase.

Thanks

 

[black92_tsi_awd]

It has the 0-5V output. Bu Pocketlogger.com hasn't told me it will work for sure. They list PLX as supported widebands.

Just would be nice to know if someone actually has one hooked up and logging.

 

[oztofrdm]

dont quote me but i believe that you have to wire it into the egt wire going into the ecu and you should be able to read it.

 

[1SloColt]

I did quite a bit of research on this and there was no formula or consistent function to use for the 0-5v output that was logged through the EGRT to get the corresponding A/F that the wideband was reading.

 

[black92_tsi_awd]

I made some posts on the Pocketlogger website. After some review, the admin advised me that AEM should read in the same as the PLX device's they currently support. It should also read in as a AFR number (ie 14.8)

I'll post up after I order and get it hooked up.

 

[Boost95]

Do a search on this. I started a thread about this a few months ago. Don't bother tapping the EGRT for the AEM wideband. It will read your widebands signal but its not accurate at all. It won't read exacltly what your Gauge is reading. Its usually off +/-1.0 or more. In my opinion its not worth it.

-Mike