650cc Injecors big enough for my setup?

[boostNmetal]

As the title states, are these going to big enough to run 22psi-ish with the setup in my profile? I want to keep IDC's below 80% of course. Thanks in advance for help!

 

[Artago]

650cc @ 100% IDC will support 46.66lbs/min
650cc @ 80% IDC will support 37.32lbs/min

from

http://www.dsmtuners.com/forums/tuning-engine-management/244522-injectors-fuel-pumps.html

How much does your turbo flow at 22 psi?

 

[boostNmetal]

I really don't know yet, the work is getting done right now by Magnus Motorsports. I'm just second guessing the injector size selection and it might not be too late to get bigger ones.

 

[LiquidX]

http://www.dsmtuners.com/forums/new...-hp-ratings-16g-big16g-evo16g.html#post653581

My car has hit 40.6lb/min with the Evo III Big 16G at 22psi.

If you could, get the next size up on the injectors if you wish. However, you can make due with the 650cc injectors if ShapeGSX was correct with his numbers. You would be over 80% IDC though.

40.6 lbs/min = 503 cfm

Edit: Above seems to reflect a standard 16g. RRE states that the E316g flows 550cfm (44.3 lbs/min). With that said then you will defiantly want the next size up injector at least.

 

[boostNmetal]

Thanks guys, I'll call Magnus tomorrow to see if they have 750's laying around.