oil pump help!!

[mnNice]

i need help with the crank pulley on the oilpump side. ill give a picture and any one that knows how to get this off your input is greatly appreciated. i need to get this off so i can get my car back on the road!!!!!

You must be logged in to view this image or video.

thanks for the help
i forgot to mention this is not my engine posted just took it off here instead of posting mine.

 

[FastJetta]

im gonna go with the biggest hammer you can find


no really i believe its pressed on... you may need a bearing puller?

 

[ziggo0]

See that large bolt? That needs to come out. You can brace the crank against the girdle with a small 2x4 to gain leverage and just take it completely out. Then it should slide out, sometimes with ease, other times it's a pain in the ass. You can try heating it up and lightly prying at it with a flat head screw driver. I found that 2 flat head screw drivers, one on each side (directly across from each other) applying even pressure props it off quite easily.

 

[96mitsugsx]

You can use a pulley puller for that

 

[KaLo_o]

yeah you need to unblot that large center bolt there, what i did is since my oil pan was off i wedged a big flathead screwdiver in the flywheel teeth and then turned it till the flywheel stoped because the screwdriver was meeting the block, then i unbolted the crankshaft sproket bolt and it came off really easy

 

[dino4g63]

You will need something to hold your rotating assembly from moving to get that bolt off or use a impact. Once the bolt is off that sprocket will slide off.

 

[herms99gst]

go to autozone...75 bucks rents u a pulley remover , ask for a chrysler harmonic ballancer remover...takes 2 secs to get it off....u get you $ back when u take it back

 

[95blackGsTurbo]

Pullers shouldn't be needed. As stated, remove the middle bolt and it will come off with some wiggling.

 

[ramsack]

yes that big bolt needs to come off. if it still doesn't come off you will need a pulley puller. something like a 3-jaw type. once it's off i would clean up the crank and the inside of that pulley because they are supposed to be tight but come off by hand.