Need help setting up MAFT

[JeanDSM]

I know i shouldnt be asking this question but im from puerto rico and its a little hard to understand some instructions ive seen by doing my research about the install of my MAF translator and sensor.

I bougth the old version for the 2g dsm but with the upgrade chip already installed., I know that the MAS plug goes to the translator harness and the other plug to the gm sensor. The white wire is it RPM signal? where does it goest to? Please tell me exact cable that goes to and better if its installed under the hood. Also i have stock injecots and an SAFC. What is the setup i need. For the aux dial and base, idle, mid, high, wot and all that.

im going to put the sensor betwen the BOV and the T/B

 

[DSMcamaro]

tap into the smaller black wire on the CAS, with the white wire.
Atleast this is how it is for my 1G, I assume 2g's are the same.

You must be logged in to view this image or video.

searching usually does good too.
http://www.dsmtuners.com/forums/showthread.php?t=215599

 

[JeanDSM]

tap into the smaller black wire on the CAS, with the white wire.
Atleast this is how it is for my 1G, I assume 2g's are the same.

You must be logged in to view this image or video.

searching usually does good too.
http://www.dsmtuners.com/forums/showthread.php?t=215599

So i only want to install the maft so i can open the bov, i also have safc so can i jst not connect the white wire and not use the rpm mode so i can setup with the apexi safc?
I have 2g and my cas plug has 3 wires.

 

[DSMcamaro]

Don't know enough about the 2g's, but this thread might help.
http://www.dsmtuners.com/forums/showthread.php?t=109081&page=2&highlight=MAFT+rpm+wire