Need guidence

[34tftf]

Ok I have a 1990 Eagle Talon Tsi, I managed to get the side 2 mounts on and the rear mount to the block. The engine and transaxle are from a 2G. I realize that I need to make a front custom motor mount but I have a few questions. The engine sits at a slight angle not to much of an angle but it leans forward, is this a major concern? Also should I continue the build without the motor mount and then take it to a shop to have them make the mount or should I just take it to the shop now with just the engine and transaxle in?

 

[B00st3d_Eg0]

i would go ahead and have it done. You don't want to pass it up now and then find out that something has gotten in the way of the mount. Atleast if its in you can tell where things need to be to stay clear of it

 

[josh408]

Take it to a shop and have them mount it. Just to be on the safe side

 

[BWeston]

You definitely want all 4, as it will wear the other 3 out faster. You can get away with 3 for a short period, as long as the back and 2 sides are on.