HX35 on stock motor w/ full support. Opinions

[93jdmlaser]

How are the hx 35s on a stock motor. I have everything to support it and cams are on the way but I want some opinons on the power and spool with a stock motor. Thanks

 

[Mackzero]

My bottomend is stock, but everything else is built. Stock motors are just fine as long as you don't do two things: REV TOO HIGH (Valve float issues) and TOO MUCH BOOST (I say this because it will become very hard to tune out knock at higher boost levels)

 

[93jdmlaser]

Yea I have arp studs and mls head gasket. I just want to know what power I can expect and is it worth it.

 

[Steve93Talon]

We're running an HX40 on a stock 130k 6 bolt with ARPs and OEM head gasket. It's seen 28psi and 8k and is holding up fine.

 

[93jdmlaser]

I saw it says the hx35 is good for lots of boost but I wont see more then 25ish and 20 around is it good for these levels?