how much hp/ 1/4 time

[1gdsmracer]

i bought a stock 1g talon and started riping into it. i am wondering what i can expect to run in the 1/4 and how many hp i will have after its tuned. my mods are as follows:
kkk 50 trim turbo t3
punishment racing manifold
punishment racing 02 housing
punishment racing fmic
greddy type rs bov
apexi n1 turbo back
750cc injectors
40mm wastegate
oil cooler
godspeed radiator
ngk plugs
ngk wires
throttle body block off
egr block off
arp head studs
cometic mls head gasket
ported head
jdm 6 bolt engine
maft pro with speed density conversion
lm-1 wide band
autometer boost, a/f,water temp
4 bolt rear end
jdm gvr4 5 spd selectable fwd or awd tranny
dss drive shaft
dss front and rear cv shafts
shep stage 4 tranny
Any ideas on what i could be running when its tuned to its max?

 

[1992awdlaser]

Any where fro 1-1000 horsepower per cylinder. And any where from 3-20 seconds in the 1/4.

Bench racing is not allowed on this site. And it is impossible to tell you what you will run or how much power you will make.

 

[ApexVIII]

hmm, probably low 8's!

EDIT: i saw that it is tuned to the max, so im going to say mid 7's now....

 

[bastarddsm]

I'd sail it will go half the speed of snail......haha ron white!

 

[whitetsi95]

I think a monitor should close this thread. No bench racing allowed.

 

[1992awdlaser]

I already reported it. It will be gone soon.

 

[SOADweskey]

throttle body block off

0hp and an infinite quarter mile. You might want to unblock that so air can get in your engine.

 

[Spln_Hrd]

Watch out shep and AMS I think we got at least 7's and at least 1400 awhp, on a conservitive dyno of course.

Take it to the dyno/track and tell us bud, infact I bet its something you could do tomarrow.

 

[RoasT BeeF]

I think a monitor should close this thread. No bench racing allowed.

What the hell is a monitor?

 

[Flash]

What the hell is a monitor?

Duh! This is a Mitsubishi Monitor.

You must be logged in to view this image or video.

 

[Laysher91]

0hp and an infinite quarter mile. You might want to unblock that so air can get in your engine.

Thats the best reply to a bench racing forum I've read so far

 

[blackgst256]

that kind of horsepower will blow the welds on the intake and you might loose a floor board two. You will probably be running very good times if you can tune the muffler bearings, and the flux capacitor to sync with the nos fogger system intergrated into tom tom. Dude we all would like to know around what we can run but until you actually complete your motor, and mods, and tuning nobody could even estimate what you will do nor do they know if you can drive or not.

 

[Boo5t_Addict]

Lol. Love the replies. To the original poster, maybe read forum rules first and you won't get flamed for asking what is a dumb question. They say in school there are no dumb questions, but ones with no answer are dumb. Your quarter mile time is even more dependent on your driving ability than it is on the power you make. 50-trims have been known to put a 1g in low 11s on pump gas. If you have your car well tuned, and are a pretty good driver, then you should do just fine. If I were you I would definitely do some research, because your first post shows that you might be kind of new to things. You don't have a way to tune it listed, so if I were you I'd look into dsmlink. It will be hands down the absolute best bang for your buck mod you will ever buy for your car. Besides, you'll need a way to control fuel and spark, so you'll have to buy an engine management system anyway. Keep reading and learning, it's the best thing you can do.

 

[99gst_racer]

1gdsmracer - No bench racing allowed here. Please re-read the site rules before furthur posting.

Run it at the track and let us know how you do.