ECUflash car won't start after ceddy mods full install

[too_genecide]

I flashed ceddymods sd with big maps to the ecu and now the cat won't start. I set the injector scaling and latency before flashing.
When I turn the key I get clicking noises from behind the dash and the cat fires but won't run. Evoscan wont connect either. I can flash the basic ceddymods with no problems.
Im not setup for sd I just need the big maps.
resolved
I had downloaded the wrong rom.
maf with big maps is the one I needed

 

[Vegas Smith]

What is this cat you speak of? leave the poor thing alone.

 

[Tiki2777]

Yea if this isnt apparent as it stands, no, you cannot run a SD rom without being setup for SD.

 

[too_genecide]

No cats Were hurt during the process.
I had downloaded the roms onto a flash drive and for some reason I didn't pay attention to the other roms in the download.
I now have a new problem with 1 byte load values dropping near zero while 2 byte load seems to stay accurate.
While 1 byte load is going haywire I get knock sum