Cant remove oil pan(rtv sealant too strong)

[1G Eclipse94928]

I have all the bolts out, and it wont even budge, I tried getting a razor blade up in there and some other little sharp blades but it just wont even move. I'm not reusing it so is there something i can put on it to get it loose?

Also tried putting a big screwdriver in the oil return line hole and pry it off, with no luck.

 

[Auto RS T]

Get a stiff paint scraper in there and tap it with a hammer.

 

[bryanwheat]

A good thin putty knife and a hammer. Hammer the blade in and go around the pan with it. Or if you aren't worried about damaging the pan than just hammer a decent sized flat head in one corner and pry it off.

 

[1G Eclipse94928]

Get a stiff paint scraper in there and tap it with a hammer.

A good thin putty knife and a hammer. Hammer the blade in and go around the pan with it. Or if you aren't worried about damaging the pan than just hammer a decent sized flat head in one corner and pry it off.

Thanks, I almost though i was going to kill myself when it finally went, but it did without breaking anything. thanks

 

[danielsl1999gsx]

Hit the gym

 

[1G Eclipse94928]

Hit the gym

Its not that, I didn't want to have it slam down on my face, i'm working with limited space so i was almost under it. Also it was installed in 1989 so it was on there pretty good.

Broke multiple razor blades just cutting into the sides....