ECMlink Can't log MAP and IAT sensors

[VisionPaintball]

I installed MAP and IAT sensors but cannot get either to log.
MAP blue wires is soldered into pin#16 (baro) on ecu.
IAT is wired to pin#24 and pin#8 on ecu.

Do i need to splice them in to the ecu harness or just cut and solder?

Thanks

 

[rvaughn]

Have you followed all the steps here:

installnewsensor [ECMTuning - wiki]

More after you respond.

 

[VisionPaintball]

Yes I believe I followed all the steps.

 

[rvaughn]

Ok, after you have assigned the sensors per step four, did you add the captured values to your list of captured values to be displayed?

See:

http://www.ecmtuning.com/demos/capturedvalues.html

 

[VisionPaintball]

ok i figured it out.

I had to add intake temp and baro to my captured values and then rename them.
Thanks for your time rvaughn.

 

[rvaughn]

No problem, glad I could offer advice.

 

[VisionPaintball]

maybe you can answer this,

Do I need to enable " Disable MAF compensation w/ SD operation" ?

Also my actual wideband is leaner than AFRatio est. Can I just lower global until they match?

 

[gofer]

You need to read this... --> Tuning Tech: How To Tune a 1g V3 SD

It will answer both those questions and then some, just read.

 

[VisionPaintball]

Hey Gofer,
Yes thats what I used so far.
OK its answered my global question but didnt specifically say about the MAF compensation with SD.

 

[gofer]

Then you need to utilize the "?" at the bottom of your ECMLink software to help in these situations.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

 

[VisionPaintball]

forgot all about that question mark button! thanks