can someone help me with my radio wiring harness?

[eclipse_16g]

i have the walmart schoche radio wire harness for my 92 talon. i wired it all up today and everything went fine there was power and all speakers worked i even drove it for an hour with everything working.
i turned the car off for about an hour while wiring my amplifier and subwoofers and now the radio wont even turn on. wtf!
there is one wire that is not connected and cant figure which color it goes ,it's the white with black strip antenna wire.
any input would be great thank you.

 

[snowborder714]

Did you happen to blow the radio's fuse?

 

[eclipse_16g]

i checked the fuse on the back of the headunit and it's fine.

 

[Cheap Car Audio]

If all of your fuses are okay, then you need to complete some other (more timely) checks. You have to pull out your deck and re-check all of your connections. If everything looks good, great. If not, fix it. Make sure there are no "open wires" hanging from the back of your deck, as this will cause a short. If there is, close them off with electrical tape. Make sure your ground wire for your deck is securely attached. Even cheap car audio systems, although some may think it's easier, can also have it's problems when installing. I hope this helps and you get your system turned on and working properly again. Good luck!

 

[DSM1G90]

You sure that the WallyWorld harness adapter kit works for the DSM and followed the wire color code listed here =>1st Gen Radio Plug and read all the material in this topic?

Good luck-DSM

 

[BM1992]

Check the fuse box under the hood I blew my fuse because when you first wire your amp you may have a little bit of power in the RCA or remote wire and may cause the actual radio fuse under the hood to blow. If thats not it I would check your grounds. Sorry if this doesn't help