Broken EPROM chip pins

[Lucas03es]

So my ECU was socketed when I purchased it. I pulled the EPROM chip out to install an Ostrich emulator, but to break in my motor I want to reinstall the chip. However, if you are reading the numbers and lettering on the chip, on the far right side, the top and bottom pins have bent and broken off. Can I still run this chip in this condition? Thanks!

 

[ilco187]

Dont think it would still work, if it did i dont think it would be operating at 100%

 

[DSM1G90]

If you're good with a soldering iron of low wattage and fine gauge solder, you can solder the pins back on the chip, but be real careful..