Bought remanufactured head what gasket should i use?

[crazycooter]

I recently purchased a re-manufactured head off Ebay and was wondering what the stock bore was and what size/material gasket I should use assuming the bottom end is stock.

 

[LiquidX]

If you don't have BOTH the head and block surfaces at a mirror shine, then use a composite gasket. The OEM one will be fine to use.

 

[92AWDHX40]

The oem is a really good choice.

 

[crazycooter]

I was lookin @ aftermarket head gaskets and noticed different bore sizes like 85.5mm 86mm 87mm which one is for stock lower end?

 

[LiquidX]

Just use the OEM gasket and its. 85.5

 

[Jankenshank]

stock bore is 85mm..... .5mm (.020") over is 85.5mm.

for just a regular build just use OEM, although i use cometic MLS without any problems.

 

[LiquidX]

The 85.5 is fine to use on a stock bore.

 

[95eclipser]

mitsu 4 layer ftw