Resolved 1g - Correct awd rear wheel bearings?

[AWD-Tony]

Do these look correct for 1g 4 bolt rear? Just want to make sure before I start. Thanks

You must be logged in to view this image or video.

Looks correct on Rockauto

You must be logged in to view this image or video.

Found pic on JNZ's site and it looks about right.

Wheel Bearing Kit (1G DSM-Rear) | JNZtuning.com

 

[92AWDHX40]

I dont know i just got the jnz kit, just installed them .

 

[AWD-Tony]

I dont know i just got the jnz kit, just installed them .

Was the inner much smaller?

 

[92AWDHX40]

I think so.

 

[AWD-Tony]

Anyone doing this will need the outer dust shield part# MB290428 & inner seal MB393807

 

[Boosted92rs]

Anyone doing this will need the outer dust shield part# MB290428 & inner seal MB393807

So actually doing this right now in the disassembling phase, question how do you get the inner bearing oit of the knuckle . A press?

 

[AWD-Tony]

So actually doing this right now in the disassembling phase, question how do you get the inner bearing oit of the knuckle . A press?

Punch it out from the outside. Pretty sure Joewrenches on YT has a video on it.

 

[Boosted92rs]

Punch it out from the outside. Pretty sure Joewrenches on YT has a video on it.

Awesome yep just got mine out, did those timken bearings work out for you?

 

[AWD-Tony]

Awesome yep just got mine out, did those timken bearings work out for you?

Yup. Seems to be holding up

 

[Boosted92rs]

Yup. Seems to be holding up

Awesome about to order some now, I found timken inner seal part # 710152 which I found on rock auto as well. Question is what about the outer seal part number having a hard time finding a national number for it.

 

[AWD-Tony]

Awesome about to order some now, I found timken inner seal part # 710152 which I found on rock auto as well. Question is what about the outer seal part number having a hard time finding a national number for it.

Just go with oe then while it’s still available.