What's Next??

[GSXlaunch]

Trying to decide what to get next. I have pretty much all of stage 1 and 2 mods...

Engine
mitsu metal head gasket
arp head studs
modified lifters
FP2 Cams ------- havnt arrived yet
5 Angle valve job
stock block
balance shafts elim

Fuel Management
780cc
AEM AFPR
SAFC
Data Logger
Walbro 255lph with re-wire
10mm wires


Induction
SCM 61 with custom O2 housing
3" GM mass
2.01 Translator
Jr.s FMIC w/2.5" piping
open K&N
HKS SSQ Bov

Exhaust
ported EVO exhaust mani
2.5" Buschur DP
2.5" muffler no cats
3" Straight thru ebay muffler

Drive Train
92 Tranny
Fidanza 8lb Flywheel
ACT 2600
symborski shift kit

Other
Joe P MBC
car lightened to 2700lbs
Greddy 52mm EGT
Autometer phantom AF
OBX Boost gauge
Shift Light

Edit...I also have the 3" QTP Electronic Exhaust Cutout...not installed yet

My goal is to be in the low 12's consistantly. I realize this turbo has 10 sec potential but the deal was too good to pass up on the scm61. Its a bit laggy but I'm getting use to it. I am leaning towards a stage III chip but not sure I really need it at this point. Opinions?

 

[iowaboostin]

After a 61 trim and most supporting mods.. I'd hafta say your best HP for the buck would be a nitrous kit.

I PM'd you, btw, check 'em