What did you do to your DSM today?

[2G4GSX63]

Went to pop the hood and it wouldn’t open so I went back to sleep

 

[KenshinHimura]

Tucked her away in the garage for the winter

 

[19gsx91]

Moved the GSX out of the garage so when my grand prix gets dropped off I can have that in there until I can figure out what my no-start issue is. no thrilled about it being outside in the soon to be snow.

 

[Rekadae]

Bought a Gates Racing Belt L19 Headstuds and a Felpro MLS HG along with other misc parts.

Sorted out a cage, seats and a new motor to use while the stock one comes out to get checked over, stock split thrust 7 Bolt is getting the new parts and some boost!

 

[d1prospect]

Re-wired my alternator harness. My original was trashed and not making good connectio. Shoutout to “ohm racing”

 

[DogWhistle]

Changed the oil, added Stabil to the gas tank, washed, waxed and put the cover on while in winter storage. Pulled the battery to use a smart trickle charger to keep it topped off.

 

[Lancer_lover]

The car is in winter storage but im gonna change som lamps and put the alternator heat shield back on . Maybe raise the bak end because its to low

 

[pksystems]

Took it out for a test drive. This thing gets into boost instantly. Time to check over logs and make sure I don't blow up the engine.

 

[ThunderChild]

Pulled my HVAC apart and vacuumed the mouse house out of everything, removed the a/c evaporator, scrubbed/disinfected the whole business, and tried fixing the last couple coolant leaks from the water-to-air setup. I hate mice.

 

[gdb1039]

Installed 3G revised lifters, screw you lifter tick!!! And installed GSC S2 cams.

 

[Kenny07]

After more than year of searching I finally found an OEM Infinity radio, not sure why but I like the stock look much more than aftermarket.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

 

[godschylde777]

Made my cardboard mounting plate for the smart coils so I can get a billet piece made.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

 

[pksystems]

Finished idle tuning. It's tough to stay out of boost with this thing.

 

[Markgst97]

Blew the engine

 

[ThunderChild]

Made my cardboard mounting plate for the smart coils so I can get a billet piece made.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

Very nice, I've been looking at doing the Toyota/denso cop once I get around to it. How
do you like the Frontline Fab valve cover? Wanting to splurge on myself and have been wanting one, as well as their oil pump...

 

[godschylde777]

Very nice, I've been looking at doing the Toyota/denso cop once I get around to it. How
do you like the Frontline Fab valve cover? Wanting to splurge on myself and have been wanting one, as well as their oil pump...

Hey there. I love it. It sets off the engine bay. Yeah I went with these coils because I wanted reliability and wanted to get rid of that pesky transistor box thing. Lol

 

[talonesi95t]

Last week I bought taps . The where expired since 2014. Installed my shifter base bushings and cable bushings and pulled my oil pan to fix the stripped turbo drain tube bolts. Took it for a drive now it's parked again.

 

[KenshinHimura]

Pulled her out of the garage and did an extensive detail and sweep on the interior due to it being in the high 50s

 

[pksystems]

Put the small spring back in my GReddy Type RS. A blip of the throttle would go rich, then SUPER lean. Idle fixed.

Made a couple small changes on the Profec-B

 

[Gwaihir]

After more than year of searching I finally found an OEM Infinity radio, not sure why but I like the stock look much more than aftermarket.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

If you need another at some point let me know. I have one not being used and it works fine

 

[CrackedDSM]

Finally installed the wideband. Yay! I love these LC2's and how easy they are to install compared to the wiring nightmare the old school LC-1 was. Lol.

 

[pksystems]

Registered and insured it!

 

[OH91awd]

swapped out to my ugly winter wheels, next thing i need to do is get it to the shop and start tearing it apart to get the cage in it.

 

[Kid Boost]

Looked at it and damn my car is sexy .

 

[92AWDHX40]

oreded my ebc from classifieds gonna install next spring, put In storage for a while, parts needed to order.