Talon gb strakes template?

[jpmxrider489]

I finaly found the strakes for the door and quarter panel after searching for 2 years. Now on the the install, does anyone have any measurements on where to drill the holes? Or a template of some sort. I want them to look just like they should. I dont want they to be off.

 

[92AWDHX40]

This may be trial and error not sure about a template most dsmers I know used another car when they swapped them over.

 

[talon2gbuyer]

send me a picture of what you need measured and I will measure mine out for you.

 

[tkrPerformance]

I have a temp plate from when I did mine.

 

[jpmxrider489]

I guess I would need specs on how high on the door towards the fender and then again for the quarter panel. Unfortunately I cant do trial and error on another car.

 

[JwpRider]

Try this link for dimensions. I would ask if someone could make a paper template from a stock door and use that for drilling. (as in the link). You only have one shot at this. If the strakes don't match up, it will look pretty bad...

http://www.dsmtuners.com/forums/appearance-interior-exterior/427993-talon-side-strakes-measurement.html

 

[LambdaJoker]

just remember, measure twice, maybe even three times, drill once.

 

[007jimmy]

i made a paper templete off the donor car out of poster board. i still have it for times like this. message me if your interested.

 

[jpmxrider489]

i made a paper templete off the donor car out of poster board. i still have it for times like this. message me if your interested.

PM ed

Heres the helpful post in that thread.

Ok lets see if I can type this out and make sense.
All measurements were done from the bottom of the door line not the bottom of the car.
#1 is towards the front of the car and it counts towards the rear.

Back piece behind the door:
1st hole one of two, 3 Inches from the door and 11 Inches from the bottom line of the door.
2nd hole 9 1/4 Inches from door and 11 1/4 Inches from bottom door line.

Door piece:
four holes
I referenced the door for this.
1st hole 3 7/8 Inch from the front and 8 Inch from the bottom.
2nd hole 13 7/8 Inches from the first hole and 9 Inches from the bottom.
3rd hole 15 7/8 Inches from the 2nd hole and 10 Inches from the bottom.
3rd hole is 16 1/2 inches from back of door.
Hole 3 and 4 are 12 3/4 Inches apart.
4th hole 16 1/2 inches from the 3rd hole and 10 1/2 Inches from the bottom door line. (3 3/4 Inches from the back of the door)

Hope that helps!

Can anyone verify that this is correct?

 

[007jimmy]

im not sure of the exact measurements but when i take my strakes off to paint the car i can verify them. the templete i made lines up with the front of the door and bottom body line along the side skirt so it makes marking and drilling really easy. just simply flip it over lay it out on the other side for the passenger side. took all of 5 mins to drill and mount my strakes.